Staple Sort Mode; Saddle Stitch Function - Sharp AR-350 Operation Manual

I Staple sort mode
Collated sets of printouts are stapled and delivered to the offset tray. Alternatively, printed paper is stapled at the
center and delivered to the lower tray. The relation among stapling positions, orientation, paper size for stapling,
and stapling capacity is shown below.
Stapling positions
Rear corner of
printouts
Center left two
positions of
printouts
Front corner of
printouts
Saddle stitch
I Saddle stitch function
Printed paper is stapled at two positions at the center and is folded in two with the center down before delivery.
<Example>
I Punch function (only if a punch module
is installed)
If the saddle stitch finisher is equipped with a punch
module as a peripheral unit, printed paper can be
punched (two holes) and delivered to the offset tray.
The saddle stitch function and the punch function
cannot be used together.
Portrait orientation
Available paper sizes: 8-1/2"
x 11", A4 and B5
Stapling capacity: Up to 50
sheets for any sizes
Same as above
Same as above
N/A
<Example>
SADDLE STITCH FINISHER
Landscape orientation
Available paper sizes: 11" x 17",
8-1/2" x 14", 8-1/2" x 13", 8-1/2"
x 11", A3, B4, A4, A4R, and B5
Stapling capacity: Up to 50
sheets for 8-1/2" x 11", A4 and
B5, and up to 25 sheets for
other sizes
Same as above
Same as above
Available paper sizes: 11" x
17", 8-1/2" x 11"R, A3, B4,
and A4R
Stapling capacity: Up to xx
sheets for any sizes
{Original 1} {Punch positions}
{Original 2} {Punch positions}
5
5-19