Table of Contents
Advertisement
Master MiniDisc operation
1
Insert a master MiniDisc.
Do not mistake the master MiniDisc for the target
one.
2
While in the stop mode, press the EDIT
button to select "NAME STAMP".
3
Press the ENTER/SYNC button.
To cancel the operation, press the /:OFF button.
4
Press the ENTER/SYNC button.
5
When the unit displays "CHANGE MD", re-
move the master MiniDisc.
Remove it without turning off the power. Or, the op-
eration will be canceled.
Operation of the MiniDisc for stamping
6
Load a MiniDisc for stamping.
7
Press the ENTER/SYNC button.
The unit will finish recording the character informa-
tion and enter the stop mode.
Note:
If the total number of tracks on the master MiniDisc does
not match that on the MiniDisc for stamping, the unit will
display "Can'tSTAMP" and turn off the power.
If this happens, adjust the total number of tracks on the
newly recorded MiniDisc using the edit operation.
00/12/26
90SEC_31_39.fm
35
Advertisement
Table of Contents
