Mercedes-Benz COMAND Operator's Manual page 58

Setting Route Options
To set: Display menu system if applica-
ble ( page 53).
Navi Mode
Select .
£
To switch option on/off: Select re-
quired option.
Depending on the previous status, the
option will be switched on D or off C.
You may activate several options.
i
The calculated route may include ferry con-
nections, for example, even if the option "Avoid
ferries" has been activated.
i
If you change the route type setting when
route guidance is active, COMAND calculates a
new route.
Block Area
You can define an area within the map dis-
play that is not to be used by the system in
calculating a route, if possible.
i
The calculated route may include a blocked
area if the destination is within a blocked area or
if the destination can only be reached using
roads that lead through a blocked area. High-
ways cannot be blocked.
To set, change or delete: Display
menu system if applicable ( page 53).
Navi Block Area
Select .
£
If no areas were previously set, the
map display appears ready to select
an area.
If areas were previously set, the
blocked area list appears.
To move the map: Press %, $,
( or &.
To set the map scale: Press Í
or Ì.
The map scale is displayed.
To enlarge the map: Press Í.
To reduce the map: Press Ì
To set the blocked area: Press C.
The blocked area appears in red.
Navigation
Introduction
Press Í or Ì to change the size
of the blocked area.
Press C.
The area is added to the blocked area
list.
A checked entry indicates an active
blocked area.
i
You can block several areas for the route
calculation and activate or de-activate them by
setting or removing the check mark.
Displaying and Changing an Existing
Block Area
To select the area you want to dis-
play or change: Press % or $.
Display/Change
Select .
57