Updating The Map Software - Mercedes-Benz COMAND Operator's Manual

Updating the Map Software

The digital data for the map software will
become obsolete, just like conventional
road maps. Optimum route guidance by
the navigation system is only achieved
with up-to-date map software. Information
on new map software versions is available
from an authorized Mercedes-Benz Center.
You can have the map software updated
there by means of a DVD or perform the
update process yourself.
Notes on DVD Discs
Only touch the discs at the edges.
Handle the discs with care in order to
prevent reading errors.
Avoid scratching, leaving fingerprints
and dust on the discs.
Use a commercially available cleaning
cloth to clean discs. Always wipe in a
straight line from the inside outwards,
never in a circular motion.
After use, put the discs back into the
box.
Protect the discs from heat and direct
sunlight.
Update Sequence
The sequence includes the following stag-
es:
Loading DVD into the DVD changer
Update process
i
The update process may take between 60
and 150 minutes, depending on the size of the
map software.
If possible, perform the update when the vehicle
is stationary. The DVD read speed is faster when
the vehicle is stationary than when the vehicle is
moving and the update therefore takes less time.
If you perform the update with the engine off and
the vehicle battery is no longer powerful enough,
COMAND may shut off automatically during the
process to protect the battery. In this case, re-
start the update with the engine running.
You can interrupt the update process and contin-
ue it at a later time. If you cancel the update pro-
cess, the navigation system is not ready for
operation.
Navigation
Introduction
G
Warning
Never leave the engine running in an en-
closed space. The exhaust gases contain
carbon monoxide. Inhaling exhaust gases
constitutes a health hazard and could lead
to loss of consciousness or even death.
47