Scanning Bluetooth Devices - ABB Cassia X1000 Installation Manual

3

Scanning Bluetooth Devices

Correct Gateway placement can be checked by scanning the Bluetooth devices within the
Gateway's range. Gateway location or orientation needs to be changed if all desired Smart
Sensors are not visible for the Gateway or if the Smart Sensor is showing weak signal level.
To enable the scanning, the router mode needs to be changed. This is done in the Basic
Page. Change the mode from "AC Managed Router" to "Standalone Router". Gateway will
automatically reboot and is operational again within 30 to 60 seconds.
In computer, tablet or mobile phone, open the following web page while having an internet
access:
http://www.bluetooth.tech/debugger/
Once the debug tool is loaded, connect the device used for configuration (computer,
tablet or mobile phone) to the WIFI network generated by the Gateway. If the Gateway is
connected to WIFI, then connect the configuration device to the same WIFI network as the
Gateway is connected.
Type in the Gateway's MAC and IP addresses to the fields Router MAC and Router IP.
Press Start Scan.
2 019 -0 2 -08
Figure 10 Cassia Bluetooth Debug Tool
S MART S ENSO R G AT EWAY
13 /16