Table of Contents
Advertisement
1MRS758861 A
Section 7
7.1
7.2
ARM600
User Manual
Arctic Patrol
Overview
The Arctic Patrol application runs on ARM600 and provides a Web-based HMI
interface. The Arctic Patrol application is used for condition monitoring and
centralized management of field devices. The centralized management enables, for
example, remote updating of the Arctic wireless devices' firmware in larger batches
as opposed to device-by-device. The asset management in Patrol is a feature of the
ABB Arctic product line, but it also supports other ABB products that have been
connected to a remote Arctic wireless device.
The available actions shown in Arctic Patrol depend on the features and devices that
the Arctic wireless devices have reported. The Arctic wireless devices' local network
is scanned for supported ABB products only, if the feature has been enabled in the
Arctic wireless device.
Registering Arctic devices to Patrol
The registration page in Arctic Patrol allows creating a configuration that can be
imported into an Arctic device during the configuration phase.
1.
Log in to ARM600's WHMI as the arctic-adm user.
2.
On the left pane under the Arctic Patrol menu, select Registration.
3.
Select the Patrol protocol to be used.
The Patrol main functionality is the same regardless of the chosen
communication protocol. The SSH protocol is selected as an example in this
instruction.
•
SSH
•
HTTPS
The border firewall must allow the use of TCP 22 (default) or
TCP 10000 port in order to get the Patrol working.
Section 7
Arctic Patrol
31
Advertisement
Table of Contents
