Example Of Application; Mounting The Lcd Monitor On A Wall - Sharp LC-15M4U Operation Manual

EXAMPLE OF APPLICATION

Mounting the LCD monitor on a wall

Note:
I Consult with your dealer and authorized shop before installation. (Various materials are used for wall. Some materi-
als may not be strong enough or thick enough to hold the mounting screws in place or support the weight of the set.)
1
Drill holes measuring 0.3 in. (8 mm) in
diameter on the wall (hollow wall, plaster
board).
2
Insert the supplied anchors into the holes,
and strike the heads of the anchors with a
hammer until the anchors are securely
installed in the wall.
Note:
I The supplied anchor screws are inserted in
anchors. Remove the screws from the anchors
before installation.
3
Position the supplied wall mount bracket in
place using the anchor screws. Tighten the
anchor screws securely.
CAUTION: • The wall mount bracket must be
installed with four anchor screws.
Be sure to thighten so that it will
not fall down under a pulling
force of at least 44 lbs (20 Kg).
• The anchors are designed for
plaster boards with a thickness
of 0.5 in. (12.5 mm). For a 0.4-
in. (9.5 mm) thickness board or a
wooden wall, find similar anchors
or screws at a hardware store.
4
Mount the back stand of the main unit on the
wall mount bracket with the supplied fixed
screw.
* To change the vertical angle of the
monitor, tilt the screen up to 8°
downward. Adjust the angle of the
monitor for the most comfortable
viewing.
24
LC-15M4U(20-28)Eng.p65 24
1.6 in. (40 mm)
0.3 in. (8 mm) ø
Anchor Screw
(Supplied)
0.5 in. (12.5 mm)
Wall Mount
Bracket
(Supplied)
Anchor
(Supplied)
Wall Mount Bracket (× 1)
Fixed Screw (× 1)
(Supplied)
01.7.24, 5:17 PM
Anchor and Screw (× 4)