DAMSON S-Series User Manual page 8

5
2
Speaker placement
1. Seating position
2. S-cube left speaker
3. S-cube right speaker
4. S-Bar with Dolby Atmos extension
5. S-Woofer*
*S-Woofer LED will flash when it is receiving
Dolby Atmos Content
8
4
1
Speaker 2 & 3 – Left and Right S-Cube
The rear speakers give an extra sense of immersion. These can
be walled mounted using the brackets included. If you prefer not
to wall mount the S-Cubes, a windowsill or bookshelf will suffice.
Each S-Cube contains four full range drivers and a woofer which
compliments the S-Woofer.
Speaker 4 – S-Bar with Dolby Atmos (S-Atmos) Extension
The S-Bar and S-Atmos unit contains upward firing speakers to
disperse the sound overhead. Place the speaker horizontally on a
stable, level surface. It should point towards the centre of the main
seating area. Do not place this vertically or on its side. Do not block
any TV sensors. Do not place it inside a cabinet as this will restrict the
upward firing speaker impacting the Atmos sound effect. To get the
best effect from Dolby Atmos, it is recommended that the ceiling
height is between 2.5 metres (9ft) and 3.5 metres (15ft) and the ceiling
is flat. The ceiling reflects the sound to provide that overhead sensation
of sound.
3
Speaker 5 – S-Woofer
The S-Woofer is the sub-woofer and nerve centre of the system
(AV Receiver). It adds a dimension of bass to enhance the listening
experience and is complimented by the bass from the surrounding
S-Cubes. There is a small stand at the back of the woofer to allow the
S-Woofer to stand independently. Most people place this at the front
of the room.