Instructions For 5.1.2 Setup Using One Hdmi - DAMSON S-Series User Manual

Instructions for 5.1.2 setup using one HDMI

PLEASE NOTE BEFORE
COMMENCING SETUP
On initial set up it is recommended
to connect the power supply of
the S-Woofer last as this provides
auto-power upon initial setup. If the
S-Woofer is powered up before the
other speakers are connected, you
will need to power off the S-Woofer
either by removing the power cable
or pressing the power button on the
remote control until the LED turns
off, then power on the system using
the remote control.
PLEASE NOTE: The S-Cubes are
set up to power on automatically
to the surround sound system only
when connected to a power supply.
14
1 2
Insert batteries into Select a location for the
Remote Control. first S-Cube surround
speaker, connect power
cable (1500mAh). For left
surround move switch on
S-Cube to Triangle.
6 7
Using a high speed HDMI Connect the S-Woofer to an output source e.g. TV or
cable (not supplied), insert projector, using an high speed HDMI cable. Place one end of
the HDMI source into the the cable into the HDMI output on the back of the S-Woofer
S-Woofer HDMI input 1. and the other end into your TV/Projector.
E.g. connect S-Woofer to
a source such as Set top
box, Cable, Xbox, FireTV,
BluRay etc.
3
DC DC
Select a location for the
Second S-Cube surround
speaker, connect power
cable (1500mAh). For
right surround move the
switch on the S-Cube to
the Square.
4 5
Position the S-Bar in Couple the Dolby Atmos
front of the display (TV/ speaker (S-Atmos) onto
Projector), connect power the S-Bar. It will snap into
cable (3000mAh). place. Position the speaker
as per the description
on the "General speaker
placement" page.
8 9
Connect the power The system will now power
supply to the S-Woofer up and configure itself. The
(2000mAh). The d S-Woofer LED in the d logo
logo on the front of the will turn red. The LED in
S-Woofer will turn red. the S-Bar d logo will light
up red and the LED on the
S-Cubes logo will display
light blue.
S-Woofer
S-Bar
S-Cube