DAMSON S-Series User Manual page 12

LED (when connected to the Home Cinema)
To work as a full surround sound setup toggle the S-Cube to the
JetStreamNet mode (light blue LED). The S-Series Home Cinema system
comes factory pre-set to home cinema mode so you should not need to
change anything when first starting up.
Solid light blue – JetStreamNet mode
Light blue and intermittent blinking red: In JetStreamNet
mode and charging.
Solid red – charging and powered off.
LED (Single S-Cube)
When one S-Cube is being used independently from the Home Cinema,
the lights in the d logo, at the top of the speaker, have the following states:
Red slow flashing – the S-Cube is powered on and is charging.
Red solid – The S-Cube is charging but is powered off. The red
LED will not display when fully charged.
Solid light blue – the S-Cube is in JetStreamNet mode but may
or may not be connected to the rest of the system.
Solid dark blue – the S-Cube is connected via Bluetooth.
Blinking alternate red and colour of the mode – when the S-Cube
is powered on, plugged in and charging and until fully charged. E.g.
Dark blue and red would indicate charging and in Bluetooth mode.
Solid yellow light – when the S-Cube is powered on and the
AUX in is being utilised.
12
LED (Two or more S-Cubes connected together via the JetStream
Net, outside of the home cinema system.
When two or more S-Cubes are being used independently from the
Home Cinema, the lights in the d logo, at the top of the speakers, have
the following states:
Parent S-Cube (operating as the main speaker): See LED (Single
S-Cube) instructions.
Child speakers:
Red flashing – the S-Cubes are powered on and charging.
Red solid – The S-Cubes are charging but are powered off.
Solid light blue – The child speaker is set to JetStreamNet but
may or may not be connected.
Blinking alternate red and light blue – Child speaker is in
JetStreamNet mode and charging. This will continue until the
unit is fully charged, after which the red light will not display.
LED indictor on
the top of S-Cube