S-Cube - Primary Functions And Setup; Individual Stereo Speaker; Multi Room Speaker Setup - DAMSON S-Series User Manual

S-Cube - Primary functions and setup

1. Individual Stereo Speaker

If you wish to use an individual speaker, you
can do so either using Bluetooth of AUX in.
1a 1b
AUX
To use the S-Cube in To connect your S-Cube to a
Bluetooth mode. Power device using a AUX/3.5mm
on. Change the S-Cube cable, insert the cable into the
to Bluetooth mode. This is AUX port. The LED in the d
a short press of the Power logo will change to yellow.
button, followed by a pause
for a few seconds. You will hear
a few short beeps. The LED
in the d logo is dark blue to
indicate is in Bluetooth mode.
You will now see the S-Cube
in the Bluetooth settings of
your streaming device which
you can connect to.
22
2
DC
The S-Cube function mode
should be set to Circle.
PLEASE NOTE: the S-Cube will
start up in the mode it was last
used in.
PLEASE NOTE: to switch
between the modes it is a
short tap of the power button
the LED will be colourless for
approximately 5 seconds.. The
mode will then change with the
correct LED colour displayed.
2. Multi speaker setup
1 2
Select a primary S-Cube
Bring the additional speakers close to the primary speaker
to connect to your device.
and short press the JetStreamNet (JSN) pairing button
Power on the S-Cube and
on the primary and secondary speaker at the same time.
connect it to your device as
Speakers are now connected. Repeat for up to 16 speakers.
per step 1a of "1. Individual
stereo Speaker.
Power on additional S-Cube
speaker(s) and change
3
function to JetStreamNet
mode (light blue LED).
Change the output of each S-Cube. Select Triangle for
stereo left channel and square for stereo right channel.
Select Circle on each S-Cube if you wish to play stereo on
DC
each speaker.