Optex THERMO-HUNTER BUILT-IN Instruction Manual page 17

H
OFF
H
ON
L
OFF
L
ON
OUT
○ ：
OUT/ Output mode
OUT
NOR
OUT
DEL
OUT
ONES
(1) Switch from OFF to ON and press the ENTER button to confi rm the
setting.
(2) When the upper limit value is displayed, press the ▲/▼ buttons to input
the temperature.
(3) Press the ENTER button to confi rm the setting.
* To cancel the setting, select OFF and press the ENTER button.
H
400
(1) Switch from OFF to ON and press the ENTER button to confi rm the
setting.
(2) When the lower limit value is displayed, press the ▲/▼ buttons to input
the temperature.
(3) Press the ENTER button to confi rm the setting.
* To cancel the setting, select OFF and press the ENTER button.
L
50
Select the output mode.
To set to the NOR mode, press the ENTER button to confi rm the setting.
To set to the DEL mode,
(1) Switch to the DEL mode and press the ENTER button to confi rm the
setting.
(2) When the time to delay output (TIME) is displayed, press the ▲/▼ buttons
to input the time. The settable range is between 0.01 to 2.00 seconds.
(3) Press the ENTER button to confi rm the setting.
TIME
0. 0 10
TIME
To set to the ONES mode,
(1) Switch to the ONES mode and press the ENTER button to confi rm the
setting.
(2) When the time to keep output (TIME) is displayed, press the ▲/▼ buttons
to input the time. The settable range is between 0.01 to 2.00 seconds.
(3) Press the ENTER button to confi rm the setting.
TIME
0. 0 10
H
300
L
0
TIME
2. 0 00
TIME
2. 0 00
17