Wiznet WizFi210 User Manual page 40

ry>]
AT+SETTIME=
<dd/mm/yyyy>,<HH:MM:SS>
AT+
GETTIME=?
AT+DGPIO= <GPIO-NO>,<SET/RESET(0/1)>
AT+VER=?
<IP>,[[Trails],[<Interval>],[<Len>],[
AT+PING=
<TOS>],[<TTL>],[<PAYLOAD>]]
AT+TRACERO <IP>,[[Interval],[<MaxHops>],[<Mi
UTE=
nHops>],[<TOS>]]
AT+BDATA= n=1 (enable) =0 (enable)
AT+XDUM=
n=1 (disable) =0 (enable)
<HW Trigger GPIO>,
<ActiveReverse>,
<SW Trigger Disable>,
AT+XEHT= <ButtonAction>
WizFi 210/220 User Manual
Table 30. Miscellaneous
(WIZnet Co., Ltd.)
address/port to the adapter port SrcPort.
Ex) AT+FWUP=192.168.3.200,667,667
Set the adaptor system time
Upon reception of this command the adaptor
sends the current system time in milliseconds
since
epoch(1970) to the serial interface. The time
format comes on the serial interface as
follows:
"Current Time in msec since epoch=xxxxxxx"
Set or reset (high/low) a GPIO pin
Ex) AT+DGPIO=31,0
Return the current adapter firmware versions.
PING the IP address provided. Trails = 0 will
ping until <Esc> C is issued.
Ex) AT+PING=192.168.3.1,5
Trace the route to the IP address provided.
Ex) AT+TRACEROUTE=74.125.155.103
If 1, bulk data mode is enabled.
If 1, UART Message is Disabled.(When Auto
Connection Mode)
<HW Trigger GPIO>
0 (Disable HW Trigger)
1 (GPIO10)
2 (GPIO29)
<ActiveReverse>
0 (Change to Active Low)
1 (Change to Active High)
<SW Trigger Disable>
0 (+++ Escape Sequence Enable)
1 (+++ Escape Sequence Disable)
<ButtonAction>
1(GPIO10)
3(GPIO21)
Ex) AT+XEHT=2,1,0,3 (Default)
AT+XEHT=1,0,0,1 (in old EVB)
34