Battery Check; Power State Management - Wiznet WizFi210 User Manual

<cid>,<Type>,<Timeout>,
AT+HTTPCSEN
D=(*)
<Page>,[Size of content]
AT+HTTPCCLO
<cid>
SE=(*)
AT+NRAW= <0|1|2>
<Frame Control>,<Sequence
AT+UNSOLICIT Cntrl>,<Channel>,<Rate>,<WmmI
EDTX=
nfo>, <Receiver Mac>,<Bssid of
AP>,<Frame Length>
(*) is about HTTP Client/SSL functions. If you want these functions, we can customize the
WizFi210 firmware.

(9) Battery check

Command Parameters
AT+BCHKSTRT
<Batt.chk.freq>
=
AT+
<Warning Level>,<Warning
BATTLVLSET= Freq>,<Standby Level>
AT+BCHK= <Batt.chk.freq>
AT+BCHKSTOP
AT+BATTVALG
ET

(10) Power state management

Command Parameters
AT+PSDPSLEE
P
<x>[,<DelayTime>,<Alarm1
AT+PSSTBY=
pol.>,<Alarm2 pol.>]
WizFi 210/220 User Manual
Table 25. Connection management
Table 26. Battery check
Table 27. Power state management
(WIZnet Co., Ltd.)
GET/POST HTTP data on the HTTP client
connection
Close the HTTP client connection
Enable / Disable Raw Ethernet support.
Unsolicited data transmission
Responses / Effects
Start checking battery
each 0 < Batt.chk.freq≤ 100 packets
transmitted.
Set the battery warning/standby level to
enable the adaptor's internal battery
measuring logic
Reset value of battery check frequency.
Stop checking battery.
Retrieve the most recent battery check value.
Responses / Effects
Enable SOC Deep Sleep power saving mode.
Request transition to Standby for x
milliseconds.
Ex) AT+PSSTBY=60000,1000,1,1
AT+PSSTBY=5000
32