NEC DS2000 Instructions page 2

Loading System Software
To use PC Card P/N 80051 to load or update system
software:
When you load system software from the PC card, the system
restarts with all the factory-installed default values. All your
prior programmed entries are erased.
1. Insert the PC Card P/N 80051 into the CPU.
2. Be sure the CPU mode switch is set to
3. Press the reset switch on the CPU to reset the system.
The LEDs on the CPU will start to cycle.
After about 1 minute, the system will restart with the new
software loaded. The LEDs will flash as shown at right.
4. Once the system restarts, switch the CPU mode switch to
.
RUN
Restoring Site Data
To use PC Card P/N 85880 to restore site data:
1. Insert PC Card P/N 85880 into the CPU.
2. Be sure the CPU mode switch is set to
3. Enter the programming mode.
ICM + #*#* + 372000 + HOLD
4. Dial 9907 + HOLD.
You see: START?
5. Dial Y + HOLD.
You see the name and date of the first database stored. If no
data bases are stored, you see:
9907: DB00 (empty)
▲
6. Press VOL or VOL
one you want to restore.
7. When the database you want to restore displays, press HOLD.
The PC Card Active LED is on during restore.
The system will automatically reset when the restore completes.
*85880INS06*
85880INS06
BOOT
.
RUN
▼
to scroll through the 16 database addresses (DB 00 through DB 15) and select the
NEC Unified Solutions, Inc.
4 Forest Parkway, Shelton, CT 06484
TEL: 203-926-5400 FAX: 203-929-0535
www.necunifiedsolutions.com
CPU Running
Slow flash: CPU OK
On: CPU starting
Major Alarm
On: Major alarm present
Off: Major alarm not present
Minor Alarm
.
On: Minor alarm present
Off: Minor alarm not present
RS-232 Port
Flashing: RS-232 port active
Off: RS-232 idle
Mode Switch
PC Card Active
LED
(Green)
(Red)
(Red)
(Yellow)
April 13, 2004
Printed in U.S.A.