Timer Operations - Sharp FO-DC550 Facsimile Operation Manual

TIMER OPERATIONS

The timer function allows you to set a transmission or polling operation to be performed automatically at a time you
specify. Up to five transmission operations or polling operations can be set at any one time, and the times they will
be performed can be specified up to a week in advance.
You can use this function, for example, to take advantage of lower night time telephone rates without having to be
there when the operation is performed.
●
For a timer transmission, scan the original into memory when you set the transmission. Scanning the original into
memory is convenient because you do not have to worry about original mix-ups or forgetting to load the original.
●
If the memory becomes full while the original is being scanned, "MEMORY FULL" will appear in the display.
• Press the [START] key (
• Press the [CLEAR ALL] key (
Your fax machine
• Select the recipient
-sending method
-time
• Select transmission
settings
Setting up a timer transmission job:
1
Press the [MENU] key.
2
Press the [ ] key (
until "1:TIMER MODE" appears, and
then press the [ENTER] key.
Selection
"1:TIMER MODE"
3
Press the [ ] key (
to select "1:SET".
Selection
"1:SET"
To cancel a timer operation, select "2:CLEAR".
) to transmit the pages that have been stored up to that point in memory.
) to cancel the entire transmission.
The scheduled
time arrives
Transmission begins
) or [ ] key ( )
) or [ ] key ( )
Recipient
beep
Transmission
/reception
4
Enter the time at which transmission
will take place with the numeric keys.
5
Press the [ ] key (
to select "AM" or "PM" and press the
[ENTER] key.
Enter two digits for the
hour and two digits for
the minute.
) or [ ] key ( )
79
5