Configure The Data Interface Cable And Com Port - SurgeX Multipak SX-DS-154 User Manual

3. Configure the Data Interface Cable and COM Port

a. Click the COM Port Setup button labeled COM.
b. Click Configure.
i. The auto configuration process will automatically set the correct device
parameters of the Data Interface Cable to operate properly with the
software and Next Gen.
© 2017 AMETEK Electronic Systems Protection / Technical Support: 1-800-645-9721 / surgex.com
• Note: This process only needs to be done once for each new
Data Interface Cable installed on the PC.
Note: This process edits Windows registry values, and so may be
•
blocked by MS Windows User Account Control (UAC) in Windows
Vista/7/8/10. It may be necessary to exit the software and restart it
with administrative rights by right-clicking the software shortcut
and choosing "Run As Administrator". It may also be necessary to
run the compatibility wizard by right-clicking the shortcut, selecting
"Troubleshoot Compatibility", and following the prompts.
User Manual
8