Table of Contents
Advertisement
Cleaning Instructions
68
The following Cleaning Instructions contain some general safety
precautions, which must be observed during all phases of cleaning.
Consult your specific optical device manuals or guides for full
information on safety matters.
Please try, whenever possible, to use physically contacting connectors,
and dry connections. Clean the connectors, interfaces, and bushings
carefully after use.
If you are unsure of the correct cleaning procedure for your optical device, we
recommend that you first try cleaning a dummy or test device.
Agilent Technologies assume no liability for the customer's failure to
comply with these requirements.
Cleaning Instructions for this Instrument
The Cleaning Instructions apply to a number of different types of
Optical Equipment. Table 2 lists the sections that are relevant to the
various modules that can be installed in this instrument.
Modules
Optical Heads
Laser Source Modules
Tunable Laser Modules "How to clean instruments with a physical contact
Return Loss Modules
LED Source Modules
Agilent 81633A/4A
Power Sensor Modules
All other Power Sensor
Modules
Agilent 81650A/1A/2A/4A/5A/6A/7A User's Guide, Third Edition
Table 2
Cleaning Instructions for Modules
Instruction
"How to clean instruments with an optical glass plate"
on page 81
"How to clean instruments with a physical contact
interface" on page 81
interface" on page 81
"How to clean instruments with a physical contact
interface" on page 81
"How to clean instruments with a physical contact
interface" on page 81
If you must clean these modules, please refer the
module to the skilled personnel of Agilent's service
team.
"How to clean instruments with a recessed lens
interface" on page 82
Advertisement
Table of Contents
