Setting Notes; Information List; Functional Scope; Functional Description - Siemens SIPROTEC 4 7VE61 Manual

2.1.2.2

Setting Notes

Interface selection
No settings are required for operation of the Ethernet system interface module (IEC 61850 Ethernet EN100-
Modul). If the device is equipped with such a module (see MLFB), the module is automatically configured to
the interface available for it.
2.1.2.3

Information List

No. Information
009.0100 Failure Modul
009.0101 Fail Ch1
009.0102 Fail Ch2

Functional Scope

2.1.3
The devices 7VE61 and 7VE63 can have depending on the order variant except for the synchronization func-
tion over numerous protective and additional functions. The hardware and firmware is designed for this scope
of functions.
Also individual functions can be enabled or disabled during configuration. Functions not needed can be thus
be deactivated.
The available protection and synchronizing functions must be configured as Enabled or Disabled. For indi-
vidual functions a choice between several alternatives is possible, as described below.
Functions that are configured as disabled are not processed by the 7VE61 and 7VE63: There are no indica-
tions, and corresponding settings (functions, limit values) are not queried during configuration.
2.1.3.1

Functional Description

Setting of the Functional Scope
Configuration settings can be entered using a PC and the software program DIGSI and transferred via the front
operator interface or the rear service interface. The procedure is described in detail in the
System Manual.
Entry of password No. 7 (for parameter set) is required to modify configuration settings. Without the pass-
word, the settings may be read, but may not be modified and transmitted to the device.
The functional scope with the available alternatives is set in the Device Configuration dialog box to match
equipment requirements.
NOTE
i i
Available functions and default settings depend on the device variant ordered (see Appendix
Information and Accessories
because of certain restrictions imposed by the hardware (see Section
2.1.3.2 Setting Notes
Special Cases
Most settings are self-explanatory. The special cases are described below.
If the setting group change function has to be used, address 103 Grp Chge OPTION must be set to
Enabled. In service, simple and fast change, over between up to four different groups of settings is possible.
Only one setting group may be selected and used if this option is Disabled.
SIPROTEC 4, 7VE61 and 7VE63, Manual
C53000-G1176-C163-3, Edition 10.2017
Type of Comments
Informa-
tion
IntSP Failure EN100 Modul
IntSP Failure EN100 Link Channel 1 (Ch1)
IntSP Failure EN100 Link Channel 2 (Ch2)
for details). Also, not all combinations of protective functions are possible
/1/ SIPROTEC 4
A Ordering
2.1.1.1 Setting Notes).
Functions
2.1 General
29