How To Store And Recall Readings; How To Delete Readings; Transfer Of Readings To A Pc - sauter TG 1250-0.1FN Instruction Manual

To clear the statistical data before starting a new set of data, the Zero-key 3-3 just
has to be pressed and released. In measurement mode, which is marked by SV, the
last value can be deleted by pressing the DEL-key. Statistics is re-calculated and
displayed again.

6 How to store and recall readings

6.1 The measurements taken are automatically saved in the memory of the instru-
ment. The memorized data can be shown and browsed by pressing and releasing the
READ-key to enter into the browsing state, which is marked by "READ" on the dis-
play.
6.2 In browsing state, all the readings memorized can be recalled on the display by
pressing the Plus-key 3-4 or the Minus-key 3-5.
6.3 To delete only one memorized value in the memory; the reading to be deleted
just has to be located on the display by the Plus-key or the Minus-key. Then the DEL-
key has to be pressed and released. If "Err0" appears on the display, it means that
there is no reading to delete any more.
6.4 The Zero-key 3-3 has to be pressed to quit the measurement state.

7 How to delete readings

7.1 To delete a reading on the display, the DEL-key has to be pressed, no matter
whether you are located in the measurement state marked "SV" or in browsing state
marked "RD". Browsing state can be entered by pressing the READ-key and meas-
urement state is entered by pressing the Zero-key.
7.2 To delete all measurements taken (readings) in the memory, the DEL-key has to
be pressed in measurement state marked by "SV" on the display for about 4 seconds
until the number of readings memorized becomes 0.

8 Transfer of readings to a PC

8.1 ATC-01 software has to be installed on the PC. During the installing process the
"continue"-button always has to be clicked.
8.2 The instrument has to be connected to the PC using the optional cable.
8.3 The Coating Thickness Gauge has to be switched on to ensure that the reading
screen is displayed.
8.4 The software has to be started and the instructions included with the software
Demo. EXE. have to be followed.
TF_TG-BA-e-1813 7