Exchanging Data With Other Organizers - Sharp OZ-5600 Operation Manual

4. Select GET DATA (APPEND), and press
5.
On the sending Organizer, press
to open the PERIPHERALS menu. Select UNIT TO
UNIT TRANSFER, and press
A submenu opens.
6. Select SEND ALL IN THIS MODE, or SEND ALL IN
THIS FILE in the Tel and User File applications.
All entries in the application or in the selected file are
transferred.
+
If the Filter function is turned on while using Tel or
User File, select SEND ALL IN THIS MODE if you
want only the filtered entries to be transferred.
For more reliable data transfer, you can connect two OZ-
5600 Organizers using the optional CE-315L cable.
To set up the Organizers for data transfer via direct cable:
1. Turn off both Organizers.
2. Open the cover of the 15-pin cable jack on each
Organizer.
3.
Plug each end of the
cable into the jack
on each Organizer.
176
.
ENTER
MENU
four times
ENTER .
4. Turn on both Organizers.
MENU
5. Press four times to display the
PERIPHERALS menu.
6.
Select SET UNIT TO UNIT PATH, then press
ENTER .
7.
Select VIA DIRECT CABLE then press
+
To conserve battery power, disconnect the cable
as soon as a transfer is completed.
GET
The and SEND
infrared transfers, not for cable transfers. You must
use the PERIPHERALS menu to transfer data via
GET
cable. Using the
initiates an infrared transfer, regardless of the
selection for SET UNIT TO UNIT PATH or whether
or not the cable is connected.
8. Transfer the data by following the same menu
procedure as for the infrared transfer shown on p.175.

Exchanging data with other Organizers

You can send information to and receive information from
ZR-5000, OZ-5500, OZ-6500 or 9000-series Organizers.
However, the OZ-5600 cannot handle graphic data from
other Organizer models. This type of transfer requires the
optional CE-315L cable if you choose not to use the
Infrared (IR) transfer.
Initial set-up
1. Turn off both Organizers.
ENTER .
keys are used only for
SEND
and keys always