Table of Contents
Advertisement
address which you wanted to set as static IP in the „board list‟. Then "Local IP, Subnet,
Gateway box will be enabled. Input Static IP address and click "setting" button. Then set the
IP address as you wanted. (PPPoE ID, Password box is disabled)
- DHCP: Set this option to use DHCP mode. Firstly, check „DHCP‟ and click „Setting‟ button. If
IP address is successfully acquired from DHCP server, the MAC address will be displayed on the
configuration windowt. (It takes some time to acquire IP address from DHCP server)
When a module on the board list is selected, IP address, Subnet mask and Gateway are
displayed. If module could not acquire network information from DHCP server, IP address,
Gateway Address and Subnet mask will be initialized to 0.0.0.0.
- PPPoE : WIZ100SR supports PPPoE for ADSL user. When you select PPPoE at the "IP
Configuration Method", PPPoE ID & Password box is enabled.
1. To set PPPoE, connect PC to WIZ100SR directly and execute Configuration Tool program on
PC. (Configuration Tool Version should be 2.1 or above)
2. Select „PPPoE‟ of the "IP Configuration Method" tab and input ID & Password.
3. Click "setting" button to apply.
4. Connect Module to ADSL Line.
5. If "Enable Serial Debug Mode" is selected, you can see PPPoE access status via serial
console.
WIZ100SR/WIZ110SR Ver. 02.02
-- PHASE 0. PPPoE(ADSL) setup process --
-- PHASE 1. PPPoE Discovery process -- ok
-- PHASE 2. LCP process -- ok
-- PHASE 3. PPPoE(ADSL) Authentication mode --
Authentication protocol : c223 00,
-- Waiting for PPPoE server's admission --ok
-- PHASE 4. IPCP process --ok
Hardwired Internet Connectivity Wizard (WIZnet, Inc.)
Figure 5. PPPoE Access Process
15
Advertisement
Table of Contents
