Working equipment
Fig. 14
Removing the cover
Opening the transport unit
9229 9992 176 0D
2013-07-08
Unpacking (III)
Note
Some of the images in this section show a different circuit-breaker type. These
images are exemplary and also apply to the vacuum circuit-breaker 3AH37/38.
Required tools:
-
Screwdriver
-
Knife/scissors
-
Lifting equipment with lifting gear.
Note
Do not use the vacuum circuit-breaker if parts are broken, i.e. if you find cracks,
flakings, bent metal parts, damaged plug-in contacts, tears or bare cables.
Send it back in its original transport unit (see "Reusing the transport unit",
page 16).
•
Place the transport unit on a level, non-slip and pressure-resistant surface.
•
Remove lifting gear or transport means.
•
Unscrew all the screws from the cover and lift it off.
•
Take out the partitions and check for damage.
Transport, storage and packing
Fig. 15
Taking out the partitions
13