Siemens 3AH37 Operating Instructions Manual page 9

Fig. 6 Removing the tensioning belts
Transporting without pallet
9229 9992 176 0D
2013-07-08
Note
When fastening the eyebolts to the pole heads, ensure that the contact surfaces
are not damaged.
• Remove all tensioning belts and bits of fastening wood.
• Remove accessory pack, if applicable.
• Screw suitable eye bolts into the outer pole heads parallel to each other.
• Hang sling gear into the eye bolts.
• Carefully lift vacuum circuit-breaker off the pallet just enough that pieces of
square timber can be placed underneath.
Note
Place pieces of square timber onto the pallet in such a way that the insulating
operating rods, contact pressure springs, angle levers and dashpots are not
damaged when setting down.
Transport, storage and packing
Fig. 7 Screwing in eye bolts and lifting the vacuum
circuit-breaker
9