Sharp FO-4700 Operation Manual page 171

NO RELAY FUNC
ONHOOK DIAL MODE
PAPER JAM
POWER SAVE MODE
RCVD CONF. FAX
RCVD PRINT HOLD FAX
RCVD RELAY REQUEST
RELAY REFUSED
REMOVE ORIGINAL(S)
SIZE ERROR
REPLACE TONER
RX DOCUMENT TRAY
OFF
A relay request has been denied because the other
machine does not have a relay broadcast function, its
memory is full, or it is not a Sharp machine.
The SPEAKER key has been pressed and the fax
machine is waiting for you to dial.
The printing paper is jammed. See the following
section, Clearing Paper Jams .
Power Save Mode is on. See Power Save Mode in
Chapter 5.
A confidential fax has been received in memory. Print
the fax as explained in Confidential Operations in
Chapter 5.
The Print Hold function has been turned on and you
have received one or more faxes in memory. Print out
the faxes as explained in Print Hold in Chapter 5.
Your fax machine has received a Relay Broadcast
request and is transmitting the requested document
to the end receiving machines. See Relay Broadcast
in Relay Request in Chapter 5.
A relay request has been denied because your fax
number has not been entered in the relay machine's
list of permitted numbers, an auto dial number not
programmed in the relay machine was specified, or
your fax number has not been programmed in your
machine.
The original document is jammed. See the following
section, Clearing Paper Jams .
This message will be followed by one of the paper
sources in parentheses, and informs you that the
paper loaded in that source is not all the same size.
The toner cartridge must be replaced.
The received document tray is not attached. Attach it
as explained in Connections in Chapter 1 (the tray
must be attached for the fax machine to operate
properly.)
Messages and Signals
169