Setting The Button Illumination - Sony RM-AX5000 Operating Instructions Manual

Setting the button
illumination
POWER
LIGHT INPUT ALL OFF
TV MOVIE MUSIC
C1 C2 C3
UTILITY OTHER
The button illumination is preset at the factory to
activate whenever the Remote Commander is
operated, and to switch off automatically if you do
not operate it for more than 5 seconds. To change
this setting, perform the following procedure.
1
Press the UTILITY button repeatedly
until "UTILITY-2" appears on the display
title.
"UTILITY-2" appears as the display title.
2
Press the Label button "LIGHT."
"LIGHT" appears as the display title.
3
2, 6
4, 7
5, 8
1
3
Press the Label button "AUTO OFF."
"AUTO-OFF" appears as the display title.
4
Press the Label button "UP" or "DOWN"
to change the auto off time of the button
illumination.
You can set the auto off time of the button
illumination from 1 to 60 seconds. Each time
the Label button is pressed, the time increases/
decreases by 1 second. For example, "5 sec" on
the display means 5 seconds.
5
Press the Label button "bOK."
"LIGHT" appears as the display title.
6
Press the Label button "ON MODE."
"ON MODE" appears as the display title.
7
Press the Label button "ALL" or "LIGHT
BUTTON" to select which buttons
activate the button illumination.
ALL: The button illumination is activated by
pressing any buttons on the Remote
Commander.
LIGHT BUTTON: The button illumination is
activated by pressing the LIGHT button only.
The setting changes and a beep sounds each
time you select the setting.
8
Press the Label button "bOK" twice.
22