Table of Contents
Advertisement
6
Press and hold the button on the other
remote control until you hear a beep.
A beep sounds and "Learning is completed"
appears in the display.
7
To program signals on other buttons,
repeat steps 5 and 6.
8
Press the Label button "bOK" twice.
Notes
• Some of the remote signals cannot be learned with the
Learning function of the Remote Commander.
• If you do not press any button on the Remote
Commander for 60 seconds between each step, the
setup procedure will be canceled and the set mode
will close. Start over from the beginning.
• If you program remote signals on the TV or Receiver/
Amplifier volume control buttons using the Learning
function (page 29), those buttons will also send the
learned signal to control Components other than a TV
or Receiver/Amplifier. If you program remote signals
on the volume control buttons of Components other
than a TV or Receiver/Amplifier, those buttons will
also send the learned signal to control other A/V
Components instead of controlling the TV or
Receiver/Amplifier volume.
• If you do not perform step 6 within 10 seconds after
performing step 5, a beep sounds two times and
"Learning was not successful. Please try again."
appears in the display, which then returns to the
display shown in step 4. Start over from step 5.
• If the Remote Commander learns signals incorrectly
in step 6, delete the learned signal. Start over from the
beginning. To delete the learned signal, see "Deleting
a Component" (page 28.)
• To avoid mis-operation, the Remote Commander will
only transmit z (record) button signals if the button is
pressed and held for over 2 seconds. Therefore, if this
button is used for a learned operation, you must press
and hold it for over 2 seconds.
The Button Press-Hold Time is customizable with
"On-PC Setup."
• When the Component has learned a signal, it will not
be reflected to the XPRESS function that includes this
Component. When the Component has learned a
signal in the On-PC Setup, it will be reflected to the
XPRESS function.
Notes on programming the
signals for an air-conditioner
About seasonal adjustments
If you change the settings of the air-conditioner for the
season, you have to program the remote
control signals of the new settings on the Remote
Commander.
If the power-on/off operation does
not work correctly
If the Remote Commander can only operate "ON" with
one button and "OFF" with another, while your air-
conditioner's remote control can operate "ON/OFF"
with a single button, program the signal on two buttons
of the Remote Commander as follows.
1
Clear the "Learned" power-on/off signal on the
programmed button.
2
Reprogram only the power-on signal of the air-
conditioner on the button by following the steps of
"Programming other remote control signals" (page
29.)
3
Program the power-off signal of the air-conditioner on
another button.
The two buttons of the Remote Commander have
been programmed with the power-on signal and the
power-off signal of the air-conditioner respectively, so
that you can operate the air-conditioner with the
Remote Commander.
30
Advertisement
Table of Contents
