Hardware Settings; Setting The Display - Sony RM-AX5000 Operating Instructions Manual

Hardware Settings

Setting the display

POWER
LIGHT INPUT ALL OFF
TV MOVIE MUSIC
C1 C2 C3
UTILITY OTHER
The Remote Commander is preset at the factory to
switch off the display automatically if you do not
operate it for more than 30 seconds. You can set
"Full Display" and "Dim Display." To change this
setting, perform the following procedure.
Full Display: shows the display in the highest
brightness
Dim Display: shows the display dimmed
1
Press the UTILITY button repeatedly
until "UTILITY-2" appears on the display
title.
"UTILITY-2" appears as the display title.
2
Press the Label button "DISP."
"DISPLAY" appears as the display title.
3
Press the Label button "FULL."
"FULL DISPLAY" appears as the display title.
2, 3
6
4, 7
5, 8
1
4
Press the Label button "UP" or "DOWN"
to change the Full Display.
You can set the Full Display from 1 to 60
seconds. Each time the Label button is pressed,
the time increases/decreases by
1 second. For example, "10 sec" on the display
means 10 seconds.
5
Press the Label button "bOK."
"DISPLAY" appears as the display title.
6
Press the Label button "DIM."
"DIM DISPLAY" appears as the display title.
7
Press the Label button "UP" or "DOWN"
to change the Dim Display.
You can set the Dim Display from 1 to 180
seconds. Each time the Label button is pressed,
the time increases/decreases by
1 second. For example, "20 sec" on the display
means 20 seconds.
8
Press the Label button "bOK" twice.
21