Table of Contents
Advertisement
Chapter 4: "SETPOINTS" Menu
"SETPOINTS" menu
4.
Before carrying out the programming of the unit, it is necessary to read and understand the indications
provided by the Manufacturer. All the programming must be carried out by qualified personnel with adequate
knowledge of the functioning of the unit and of the content of this manual.
4.1
Setpoints page 1: SETPOINT ACCESS
SETPOINTS PAGE 1
SETPOINT ACCESS
ENTER ACCESS
CODE: X X X
SETPOINT ACCESS
ENABLED
SETPOINT ACCESS
ONLY VIEW
ENTER NEW ACCESS
CODE? NO
ENTER NEW ACCESS
CODE: X X X
Displayed only if "YES" has been
selected in the previous line.
NEW ACCESS CODE
STORED = X X X
IPR-D RELAY:
IPR-D - FIRMWARE
END OF PAGE
CURRENT PROTECTION RELAY - IPR-D
This PAGE contains messages for Setpoint access.
Press LINE key to pass to next Line.
Enter the THREE-DIGIT access code using the digits from1 to 9.
[→ § 3.8 -
]. Manufacturer code: 111.
It indicates that the entered code is right and that the SETPOINT values can be modified.
It indicates that the entered code is not right and that the SETPOINT values can only be
read.
RANGE:
..............................................................................................................
The user can enter his own customized access code.
• to confirm the code programmed by the Constructor.
1. press LINE key to pass to IPR-D RELAY: IPR-D – FIRMWARE
• to replace the code programmed by the Constructor with the customized one:
1. press ▲VALUE key→ YES will be displayed (the following line will be displayed);
2. press STORE key;
3. enter the new code that is automatically confirmed after entering;
4. press LINE key to pass to the following line.
Enter the THREE-DIGIT access code using the digits from1 to 9.
[→ § 3.8 -
]. Manufacturer code: 111.
It indicates that the new access code has been stored.
It indicates the IPR-D firmware version.
Last LINE of PAGE 1.
Press LINE or ▲PAGE, to pass to the first line of PAGE 2.
4.1
NO; YES
Manual P/N: IPR-D GBM 01/09/2006
Advertisement
Table of Contents
