Test Mode By Control; Trouble Shooting - Midea US-FC70-DS12DSH/C0401E Service Manual

Service manual for Wash and Dry Combo product

4. TROUBLE SHOOTING

4.1 Test mode by Control

Note: Before entering the test mode, you should empty the machine so that there is no
water left in the drum. You can run a spin cycle or open the service panel from the front of
the unit to get all water out. Then make sure all parts are in their original position for check
running.
Shut down the machine by pressing the on/off button, Disconnect the plug from the power supply, and
connect the power again. Press the buttons in sequence of Temp-soil-temp-soil, then, the unit enters
test mode, and "t01" displayed.
4.2 Test modes
Test mode list
Code Function
t01 Model Setting
t02 Error Code Review
t03 Software Version
t04 Display Test
t05 Pump Test
Notes:
1. t01, t03, t11,, t13, t14, t15 can't be used for service!
2. To activate the test mode, Press the "Start/Pause" button once.
3. Press the "Start/Pause" button to again to start the function test.
4. When the test mode is operating, press the "on/off" button will stop the test and exit to status for
Test mode selection.
-------------------------------------------------------------------------------------------------------------------------------------------------------
Code Function
t06 Water Switch Test
t07 Water Heater Test
t08 Drying Heater Test
t09 Wash Function Test
t10 Spin Function Test
－ 14 －
Midea America Company
Code Function
t11 Factory Test Mode
t12 Water inlet valve Test
t13 Factory Test Mode
t14 Factory Test Mode
t15 Factory Test Mode