Package Contents; Install The Module In The Rack - ProSoft inRAx MVI56-DEM User Manual

MVI56-DEM ♦ ControlLogix Platform
Honeywell DE Communication Module
Note: You can install the module in a local or remote rack. For remote rack installation, the module
requires EtherNet/IP or ControlNet communication with the processor.
1.2

Package Contents

The following components are included with your MVI56-DEM module, and are
all required for installation and configuration.
Important: Before beginning the installation, please verify that all of the following items are
present.
Qty. Part Name
1 MVI56-DEM
Module
1 Cable
1 Cable
If any of these components are missing, please contact ProSoft Technology
Support for replacement parts.
1.3

Install the Module in the Rack

If you have not already installed and configured your ControlLogix processor and
power supply, please do so before installing the MVI56-DEM module. Refer to
your Rockwell Automation product documentation for installation instructions.
Warning: You must follow all safety instructions when installing this or any other electronic
devices. Failure to follow safety procedures could result in damage to hardware or data, or even
serious injury or death to personnel. Refer to the documentation for each device you plan to
connect to verify that suitable safety procedures are in place before installing or servicing the
device.
After you have checked the placement of the jumpers, insert MVI56-DEM into the
ControlLogix chassis. Use the same technique recommended by Rockwell
Automation to remove and install ControlLogix modules.
Warning: When you insert or remove the module while backplane power is on, an electrical arc
can occur. This could cause an explosion in hazardous location installations. Verify that power is
removed or the area is non-hazardous before proceeding. Repeated electrical arcing causes
excessive wear to contacts on both the module and its mating connector. Worn contacts may
create electrical resistance that can affect module operation.
Turn power OFF.
1
Page 10 of 80
Part Number Part Description
MVI56-DEM Honeywell DE Communication Module
Cable #15, RS232 For RS232 Connection to the CFG Port
Null Modem
Cable #14, RJ45 to For DB9 Connection to Module's Port
DB9 Male Adapter
cable
Start Here
ProSoft Technology, Inc.
March 6, 2008