Motorola Canopy AP Getting Started page 8

C A N O P Y
Motorola Wireless Internet Platform
Connecting Your Multiple Canopy AP Units
- Once the Canopy AP Units have
been assigned unique IP addresses,
they are ready to be connected to the
Canopy AP Installation Kit. Mount
the Canopy AP Installation Kit near
the Canopy AP Units.
- Connect AC to the Canopy AP
Installation Kit.
- Connect a CAT-5 Ethernet cable,
such as Belden-E Datatwist ® 5E
1585LC, between the AP
Installation Kit and each CANOPY
AP Unit.
- Connect an RJ11c phone cable
between the AP Installation Kit
Sync connectors and each
CANOPY AP Unit.
- Connect a CAT-5 Ethernet cable
between the AP Installation Kit and
a 100baseT network.
- Consult the AP Installation Kit user guide for more detailed
instructions.
One of the Sync connectors on the Canopy AP Junction is labeled
MASTER. Make a permanent note of which Canopy AP Unit is connected
to the MASTER Sync connector.
- On the Canopy AP Unit internal configuration screen, select Sync AP
to Received Signal to the Sync Input field for all connected to the
Canopy AP Junction. The GPS receiver within the Canopy AP
Junction will generate sync for all attached Canopy AP Units.
Page 8
GPS Antenna
6 Canopy
AP Radios
Ethernet
& Sync
Cables
Multiple
Canopy AP
Installation
Kit
AC
Sync Input
Event Log
Information on Event Log is for tech support personnel only.
The user should not clear this data unless instructed to do so by tech
support personnel.
C A N O P Y
Motorola Wireless Internet Platform
Page 17