Advertisement
C A N O P Y
Motorola Wireless Internet Platform
Connecting Your Canopy BH Units
CANOPY
BH
Ethernet
Crossover
Fixed Network
Cable
Access
AC Adapter
-
Connect a CAT-5 Ethernet cable, such as Belden-E Datatwist ® 5E
1585LC, between the power adapter Ethernet patch and the RJ45
socket on the CANOPY BH.
-
Plug the AC Adapter into an AC outlet. Plug the other side of the
power adapter's Ethernet patch into a computer Ethernet port, hub,
router, or Ethernet switch.
•
The Canopy BH units are depicted in the diagram above using a
Over Ethernet cable,
to connect to a Fixed Network such as a
SWITCH, or
ROUTER. If connecting to a COMPUTER, use a
Straight-Thru Ethernet
cable.
•
Although Ethernet straight-through or crossover cables minimally
connect pins 1,2,3, & 6, insure that your Ethernet cable passes through
all connections (pins 4, 5, 7, & 8 convey power up to your Canopy
radio).
If one side or the other employs a Canopy AP Installation Kit, power is
provided without the need for an AC Adapter ... however, the Ethernet
cable should be straight (not cross-over) to the Canopy BH unit because the
AP Installation Kit provides internal cross-over patches for all connected
Canopy AP units.
Page 10
CANOPY
BH
Ethernet
Crossover
Fixed Network
Cable
Access
AC Adapter
Cross-
HUB,
Congratulations!
You have purchased a Motorola CANOPY backhaul radio, the latest
innovation in high speed wireless networking. The Motorola CANOPY
radio lets you easily network at high speeds with no wiring.
-
Network speeds of 20Mbps.
-
Small compact design.
-
Transparent 100baseT networking.
Getting to Know your Radio.
Canopy AP
RJ45
Connection
Connector
LEDs
Base Cover
Ethernet
Cable
C A N O P Y
Motorola Wireless Internet Platform
The base cover snaps off to
expose the RJ45 connector where
the Ethernet Cable will be
plugged in, as well as connection
LEDs used for dagnostics. The
base cover is released by
depressing a release lever on the
back of the base cover.
Base Cover
Base Cover
Release
Ethernet
Lever
Cable
Page 3
Advertisement
