Advertisement
C A N O P Y
Motorola Wireless Internet Platform
Configuration
Use this page to configure operating parameters for the Canopy AP Unit.
Sync Input, RF Frequency, and Lan1 IP Address will require
reconfiguration for multiple AP Unit Sites.
Page 12
Device type
The second line should read Access Point – Multipoint
Mode. Any other label indicates an inappropriate
preconfiguration of the CANOPY radio
Sync Input
Default is Generate AP Sync Signal. In multiple AP sites,
all APs should be set to Sync AP to Received Signal when
fed from the Canopy AP Junction.
RF Frequency
Select the RF frequency for this Canopy AP Unit. The RF
Carrier
frequency for all Canopy AP Units should be coordinated
to insure that adjacent cells operate on different
frequencies.
Downlink Data
Preallocate a division of the total bandwidth between
downlink (to the subscribers) and uplink (from the
subscribers). Typical web-browsing applications typically
are served best by more bandwidth allocated to downlink.
The default value is 75%.
High Priority
is preconfigured to 0. This value permits establishing a
Uplink Percentage
portion of uplink bandwidth for VoIP services.
Total
is preconfigured to 3. This value permits tuning of the
NumUAckSlots
number of slots per frame for Uplink Acknowledgements.
Uacks Reserved
is preconfigured to 0. This value permits tuning of the
number of slots per frame for Uplink Acknowledgements
High
for VoIP services.
NumD AckSlots
is preconfigured to 3. This value permits tuning of the
number of slots per frame for Downlink
Acknowledgements.
DAcksReserved
is preconfigured to 0. This value permits tuning of the
number of slots per frame for Downlink
High
Acknowledgements for VoIP services.
NumCtlSlots
is preconfigured to 3. This value permits tuning of the
number of contention slots per frame based on the number
of registered SM users.
NumCtlSlots
is preconfigured to 0. This value permits tuning of the
Reserved High
number of contention slots per frame for VoIP services
based on the number of registered SM users.
Uplink BandWidth
is preconfigured to 9999. This value permits creating a per
Cap (KBPS)
SM user capacity for Uplink data.
Dwnlink
is preconfigured to 9999. This value permits creating a per
SM user capacity for Uplink data.
BandWidth Cap
(KBPS)
C A N O P Y
Motorola Wireless Internet Platform
Page 13
Advertisement
