Trouble Shooting; Environmental Protection; Available Accessories - Jet JWSS-22B Operating Instructions Manual

Regular: Standard blade form with evenly spaced
teeth and zero-degree rake angle. Offers clean
cuts at slower feed rates.
Skip Tooth: More space between teeth, for good
chip removal and fast cuts.
Double Tooth: A skip tooth with larger gaps
between tooth sets; good chip removal, fast
cutting.
Reverse Tooth: Prevents underside tear-out,
leaves clean edge.
Spiral: Cuts on all sides without turning workpiece;
limited applications but good for looser fretwork.
Crown Tooth: Cuts on both up and down strokes
for clean, splinter-free edges. Depending on blade
oscillation settings, a crown tooth blade may often
be turned over for a fresh set of cutting teeth.
Figure 30: blade forms

10. Trouble shooting

Motor will not start.
*No electricity-
check mains and fuse.
*Defective switch, motor or cord-
consult an electrician.
Motor will not start: fuses blow or circuit
breaker trips.
* Short circuit in motor or loose connections-
Inspect all connections on motor for loose or shorted
terminals or worn insulation.
Tilting mechanism difficult to move.
*Caked dust or other obstruction in trunnion
assemblies-
Clean trunnion areas and apply light dabs of
grease to contacting parts.
Blades frequently break.
*Incorrect blade tension-
Set proper tension.
*Blade being overworked-
Reduce feed rate.
*Blade twisting in workpiece-
Avoid side pressure on blade. Reduce feed rate.
Excessive vibration.
*Arms/linkage system not tight-
Tighten trunnion lock knob.

11. Environmental protection

Protect the environment.
Your appliance contains valuable materials which can
be recovered or recycled. Please leave it at a
specialized institution.

12. Available accessories

14
Stock number
727200S
Steel stand