Technical Data; Noise Emission; Contents Of Delivery - Jet JWSS-22B Operating Instructions Manual

A Arm Adjustment Knob
B Upper Arm
C On/ Off Switch
D Variable Speed Control
E Rocker
F Blade Tension Lever
G Blade Clamp
H Upper Blade Guard
I Dust Holes
J Table Slot
K Cast Iron Table
L Dust Port
M Lower Blade Holder
N Tilt Lock Handle
O Tilt Adjust Knob
P Detent Plunger
Q Tilt Angle Scale
R Blade Rack
S Leveling Foot
T Hold-down
U Blade Nozzle
V Arm Lift Retension Screw
W Magnetic On/ Off Switch
X Motor

4.2 Technical data

Horsepower
50W
Phase
single
Voltage
230 V
Cycle
50Hz
Stroke
18mm
Speed variable
stroke/min
Throat capacity
Blade type used plain-end (pinless)
Maximum cutting depth
Arm tilt
degrees right
Table dimensions (LxW)
Table slot width
Table height from floor, on optional stand
adjustable; 812mm to 965mm
Optional stand footprint (LxW)
Overall dimensions – saw only (LxWxH)
Overall dimensions – saw on stand (LxWxH)
Shipping dimensions – saw only
900mm x 450mm x 480mm
Dust port outside diameter
Net weight, saw only
Net weight, optional stand only
Overload fuse 5A, 250V
Reference current
Extension cord (H07RN-F):
Installation fuse protection
Isolation class
400 to 1550
560mm
130mm
48 mm
45 degrees left; 45
600 x 322 mm
5mm
711 x 648 mm
838 x 394 x 445 mm
838 x 648 x 1219 mm
38mm
31 kg
9.8 kg
5.5 A
3x1,5mm²
10A

4.3 Noise emission

Acoustic pressure level (EN ISO 11202):
Idling
In operation
The specified values are emission levels and are not
necessarily to be seen as safe operating levels.
As workplace conditions vary, this information is
intended to allow the user to make a better estimation
of the hazards and risks involved only.
4.4 Content of delivery
1 x Scroll saw
4 x Leveling feet with hex nuts
2 x Lower blade holders
1 x Dust port
1 x Blade rack
5 x Blades, skip type
4 x Rubber washer – (HP5)
Stand ((JET Option # 727200S)
Refer to Figure 8, (5.3 Mounting to bench or stand)
2 x Long top braces – (#3)
2 x Short top braces – (#4)
2 x Short bottom braces – (#7)
2 x Long bottom braces – (#8)
4 x Legs – (#5)
4 x Leg extensions – (#10)
Hardware package (see Figure 2-1); contains:
4 x Hex cap screws 5/16x1 – (HP1)
24 x Carriage bolts 5/16x1/2 – (HP2)
32 x Flat washers 5/16 – (HP3)
28 x Hex nuts 5/16 – (HP4)
I
4
LpA 72,5 dB(A)
LpA 78,4 dB(A)
Fig 2