Download Print this page

Warranty Card - PRITY K1 Optima Technical Description And Operating Instructions

Fireplaces, stoves and fireboxes to build-in using solid fuel

Advertisement

When a chimney is located in an area of overpressure caused by a wind.
On right connection, servicing and maintenance the fireplace doesn't give off smoking emissions in the premises. If nevertheless this occurs, the premises are
aired and the cause of the filling with smoke must be found out and removed.
Don't burn: garbage, stuck or painted softwood, plywood or boards of wooden parts, wooden sleepers or other refuse containing artificial chemical admixtures,
since poisons don't burn, but only change their composition and when they are thrown away in the atmosphere, they lead to unpredictable consequences.
Cleaning, maintaining and preservation
During operation the door of the fireplace must be closed. On opening of the door to refuel, the openings for the primary air are closed and one shall be careful
not to drop down fuel and to prevent it from falling out of the fireplace.
The power of the fireplace is regulated with the help of the valves for the primary air and on the outlet for the flue gases.
The fume valve of the chimney adjusts the quantity of flue gas leaving the appliance. It is controlled by the handle located in the upper part of the connecting
pipe for the chimney stacks.
The cooking stoves are switched over in regime "baking" through pulling out the valve over the oven.
Don't touch the fireplace with your bare hands, while it is hot.
The ash-pan shall be cleaned daily. Don't throw the ash in plastic vessels.
Clean regularly the passage sections of the flue gases in the fireplace and the pipes.
The painted surfaces are cleaned with a damp cloth. Don't use cleaning detergents. If you want to freshen up the paint, use a suitable phial of sprayer.
To clean easier the cavities in the cooking stove the movable bottom of the oven is raised.
The glass pane is wiped with a damp towel, and when necessary it can be washed with cleaning detergents or water. The hardened glass panes are washed
and dried when cold.
To prevent the condensation and a possible corrosion, when the fireplace is not operated for a long time (for example during the non-heating period), it must be
cleaned from the ash and remainders of fuel, and the adjusting elements - open, for a better circulation around and through the fireplace.
Do not perform any unauthorized modifications in the design!
During repairs only original spare parts from the producer shall be used.
The company operates a guarantee and post-guarantee service and can replace water jackets.
The guarantee is not valid for fireplaces with bulging water jackets, which are a result of the increased pressure in the system beyond the admissible one on
incorrect installation.
IT IS RECOMMENDED THAT THE INSTALLATION BE DONE BY A SKILLED SPECIALIST.
Company: ......................................................................................................................
Address: ........................................................................................................................
The system has been installed in accordance with the regulations for safe operation. A 72-hour trial has been carried out in operation conditions.
Installer: .......................................................................................................................
The products of Prity Co. are made to conform with an approved technical documentation and a standard model tested in an independent laboratory according
to the requirements of Bulgarian State Standard : BDS EN 13240:2006r., BDS EN 12815:2006, BCS EN 13229:2006 for safe work and efficiency.
The warranty period of'the product is 24 months from the date of the sale from the trade network, provided all requirements for correct transportation, installation
For the removal of defects, the fireplace must be presented to the dealer, from whom it was purchased or directly to the producer, as its warranty card should be
The firm producer satisfies all claims, except in the following cases:
- formation of condensation;
- broken glass or bricks;
- return of flue gases (smoking);
- when a grate is melted or there are deformations in consequence of temperature overloading
- the requirements for mounting and operation indicated in the present instructions and the instmctions for mounting water installations were not observed or on
damage through installer's fault;
- the defects were caused during transportation;
- The fireplace has a bulging water jacket as a result of increased pressure in systems with forced circulation. It is recommended that partial gravitation - with
one or two radiators at least, should be built;
- The fireplace had been connected in a closed system under pressure with a faulty safety valve or with a valve working under pressure over 1,5 atm.
The warranty is valid only if this guarantee card is filled in and signed legibly in ink or in a ball-point pen and stamped.
In accordance with Directive 99/44/EC of the European Parliament for sale of goods and associated guarantees, the seller shall be liable to the customer for
any lack of
The fireplace was delivered in a good working condition to the buyer:
.....................................................................................................................
(Full name of the purchaser)
Adress:.........................................................................................................
Company name ...........................................................................................
City (town).....................................................................................................
Invoice No. ...................................... dated from ..........................................
PURCHASER ..................................... SELLER .........................................
(Signature)
10
Open
THE INSTALLATION HAS BEEN PERFORMED BY:
and operation are observed. For the models W the warranty is 3 years.
conformity of goods that are subject of the sales contract. Transportation expenses are at the expense of the customer.
Producer: "Prity 95" Ltd. Bulgaria, town of Liaskovets, 33, M. Raycovich Str.
(Date of the sale)
(Signature and stamp)
Closed

WARRANTY CARD

obligatorily enclosed.
ATTENTION!
www.prity-bg.com
READ, KEEP AND OBSERVE THE PRODUCER'S INSTRUCTIONS!
Last update: 10.05.2012
PACKING LIST
The fireplace is complete and equipped
with the following pieces and units:
- body of the fireplace;
- a door with glass;
- a drawer- ash-tray;
- cast-iron grate;
- a set of handles with a latch and an air regulator;
- technical description.

Advertisement

loading