Table of Contents
Advertisement
SPEEDLAN Installation and Operation User Guide
Setting Up the IP Addresses (IP Host Setup)
from the public. This means that the public will view only one public and valid IP
address.
5
Enter the appropriate outgoing information:
Public IP Address
•
This is the IP address for the outside network. If you have more than one public
address, you can assign it to node on a private network (One-to-One NAT). Therefore,
all requests for a particular IP address from the outside or public network will be trans-
lated to the appropriate private IP address. This may be necessary if you have a server
or workstation (host) that needs to be connected to a remote network.
Private IP Address
•
This is the IP address for the inside or private network only, which hides behind the Pub-
lic IP address.
Public IP Mask
•
This address assigns the Subnet mask to the Public (Ethernet) portion of the SPEEDLAN
brouter.
Private IP Mask
•
This address assigns the Subnet mask to the private network interface.
Note: Click Select to view the IP Mask List. Select the appropriate IP Mask and click OK.
6
Click OK.
7
After you have finished entering the appropriate information, click OK.
8
Now save the changes to the bridge or router. From the File menu, choose Save Config.
9
A message box appears informing you that the information will be saved to the bridge or
router. Click Yes. The Configurator confirms that the configuration has been saved. Click
OK. The SPEEDLAN ISP shelfmount brouters will automatically reboot at this point.
7-21
Advertisement
Table of Contents
