Table of Contents
Advertisement
SPEEDLAN Installation and Operation User Guide
Step 4. Ground the Antenna
Step 5. Connect the Wireless Bridge to the Power Supply
Step 6. Connect the Wireless Bridge to any Available Outlet of the Ethernet LAN
Step 7. Repeat If Needed
Repeat Steps 1-6 for all of the SPEEDLAN brouters that will be communicating with this one.
Quick Start
a) Mount the lightning arrestor to a solid surface.
b) Run the grounding wire from the lightning arrestor to a proper ground source such as a
grounding rod or roof ground wire.
c) Seal the entire lightning arrestor with the black waterproof sealant insulation putty that
comes in the installation kit. Note: The lightning arrestor is NOT
a) Make sure the switch on the power supply is set to the proper voltage (110V or 230V AC).
b) Connect the power cord's IEC 320 female outlet to the IEC 320 male power inlet on the
back panel of the SPEEDLAN brouter.
c) Connect the power cord to an external power outlet (110V or 230V AC).
a) Connect the RJ-45 connector on a standard Ethernet cable to the RJ-45 port on the back
panel of the brouter.
b) Connect the other end of the Ethernet cable to your Ethernet hub, switch or router.
NOT waterproof.
NOT
NOT
2-5
Advertisement
Table of Contents
