5-4
*Enable Incoming Network Address Translation
•
This option enables a company to unmap public network IP addresses into network IP
addresses. For more information, see Part III - Setting Up NAT, page 7-20.
*Enable DHCP Server
•
This option enables the DHCP Server on the SPEEDLAN. For more information, see Part III -
Setting Up NAT, page 7-20.
Enable Access Point Radius Authentication
•
This option is not available at this time
Enable SectorPRC Radius Authentication
•
This option is not available at this time.
Enable IP/UDP/TCP Security Filters
•
This option is not available at this time.
Enable AppleTalk Security Filters
•
This option is not available at this time.
Enable Novell Security Filters
•
This option is not available at this time.
Enable Watchdog Reboot Timer
•
This feature instructs the brouter to reboot in the event that the brouter fails to receive any
incoming packets, from any port, for a period of 10 minutes. The brouter will assume an
error has occurred and will reboot. If, after the brouter reboots, it does not receive an
incoming hello signal, the brouter will listen for the hello signal until the user reboots the
brouter manually. The Watchdog will recognize when a signal has been re-established and
will reset the timer accordingly.
SPEEDLAN Installation and Operation User Guide
Configuring SPEEDLAN