Presidential Billiards KENSINGTON Installation Instructions

KENSINGTON BILLIARD TABLE INSTALLATION INSTRUCTIONS

Tools required by the installer:

3/8" and 1/2" Drive ratchet and Extension
9/16" and 1/2" Sockets for above
9/16" and 1/2" Combo end wrench
# 2 and # 3 Phillips screwdriver
1/8" & 3/16" Drill bits
Level and shim material
Material to fill slate seams (beeswax, water putty, bondo, etc.)
Prior to installation of the table please check for damaged or missing parts. Call Presidential Billiards at
866-728-2253 if there is a problem. The hardware is packed in several different packets. This coincides
with the steps in this installation instruction and will hopefully reduce your time to verify what hardware
is required where. It is suggested that you retain the bolts in their respective packets for ease of
installation.
STEP 1 TRESTLE AND LEG ASSEMBLY
The trestle assembly consists of a stretcher attached to legs.
Attach legs to stretcher using 3/8" x 2 3/4" bolt, 1" washer, 3/8 nut.
1.1
1.2 Check bolts for attaching legs to leg stretcher to ensure they did not loosen in transit.
STEP 2 FRAME ASSEMBLY
*Caution – Do not tighten any frame assembly bolts until all are in place!!
2.1 Place the leg/trestle assembly in the location selected for the table.
Loosely attach leg beams to legs using 3/8" x 8" bolt, 1 1/4" fender washer, and 3/8" nut. Make
2.2
sure beams are flush or slightly above leg, if not slate will not be flat on beams causing leveling
problems.
Loosely attach long beam to leg beams using 5/16" x 3 1/2" bolt, half-moon washer and 5/16"
2.4
nut. Attach slate beams to long beam using 5/16" x 3 1/2" bolt, half-moon washer and 5/16" nut.
Repeat for other long beam.
2.5 Square and tighten all bolts on frame.
Attach end slate beam to frame using 5/16" x 3" bolts, 1 1/4" fender washer, 5/16" nut. Recheck
2.6
square of frame.
Attach long center beam to legs using 3" screws.
2.7
Small Hammer
Tape Measure
13MM Combo end Wrench (2)
3/8" Electric drill/ driver
Utility Knife
Stapler and staples
1