Configuration Tab; Signals - IntesisBox IBKNXMEB0100000 User Manual

KNX – M-Bus
®
IntesisBox

4.2.3 Configuration tab

Select the Configuration tab to configure the connection parameters. Three subsets of information are shown in this
window: General (Gateway general parameters), KNX Server (KNX interface configuration) and M-Bus (M-Bus
configuration parameters).

4.2.4 Signals

All available objects, KNX objects, its corresponding M-Bus register and other main parmaters are listed in the signals
tab. More information on each parameter and how to configure it can be found in the IntesisBox MAPS user manual.
This information is subject to change without prior notice
IntesisBox is a registered trademark of Intesis Software S.L.U.
Figure 4.2 IntesisBox MAPS configuration tab
Figure 4.3 IntesisBox MAPS Signals tab
User Manual r1.0 EN
email: info@intesisbox.com
web: www.intesisbox.com
phone: +34 938047134
12/17