Standard Configuration; Connect Tab - RF IDeas pcProx Plus User Manual

Standard Configuration

This Standard Configuration area provides all the options and details necessary to configure a
connected device.
USB
Ethernet

Connect Tab

The connect tab offers the various ways a device can connect to the configuration utility. The
different selections allow the user to choose the connection type for the specific logical protocol of
their reader.
Note: Only one connection type at a time will be shown.
USB: Make this selection if the connected device has a USB logical protocol. The utility will then
proceed to scan any available USB bus for connected devices.
Serial: RS-232 and Virtual COM Ports: This option provides devices that are RS-232 or Virtual
COM port logical protocols to connect to the utility. This section scans for RS-232, physical COM
port devices, virtual COM port devices, including USB, CDC and PCMCIA devices.
When making this selection, the lower and upper limits of the COM ports to scan need to be
set. The port values range from 1 to 256. The default COM ports are set at 1 thru 8.
Default 1..8: This option sets the COM port values back to the default of 1 and 8.
Note: Serial devices may slow when scanning a wide port range.
23
Chapter 3 Software
Serial: RS-232
and Virtual
COM