RF IDeas pcProx Plus User Manual page 15

(Connect--Cont.)
Connect to USB: Connects to current specified reader through USB
Connect to Serial: Connects to current specified reader through serial
Connect to Ethernet TCP/IP: Connects to current specified reader through ethernet TCP/IP
Why use the Connect to feature? The connect to feature allows the utility to connect to a
device through the specified port upon selection. This is especially helpful when users are
switching out and changing devices with different connections.
Disconnect: Disconnects all connected devices from every available interface connection from the
configuration utility.
Note: For further information on the disconnect option, see the disconnect portion of the
Icon Toolbar section on page 21 of this manual.
Device Menu
The device menu lists the options for resetting, writing to, and reading the device's data memory. The
device menu options are altered depending on the type of device that is connected. A single
configuration reader device has different device menu options than a two configuration reader device.
Single Configuration Readers:
Reset to Factory Defaults: Resets all configuration parameters to factory defaults.
Read Settings: Displays the current connected device configuration
Write Settings: Writes the current configuration settings to the connected device
Note: For more information on the Write Settings option, see the Write Settings/Write
Active portion of the Icon Toolbar section on page 21 of this manual.
pcProx Plus - 2 Configuration Reader:
Reset to Defaults: Resets all configuration parameters to defaults. Defaults are set as HID
Prox and RDR-758x Equivalent (covers 5 different card types; HID iCLASS CSN, ISO 14443A
CSN, ISO 15693A CSN, MIFARE CSN, MIFARE DESFire CSN)
Reset to Stored Settings: This selection allows users to reset the device to their own
personally defined stored settings.
Write Stored Settings: writes the current configuration settings to stored settings
Note: Stored settings are defined as configuration settings created by a user and
set/written to the device through the utility as a stored settings.
15
Chapter 3 Software