Table of Contents
Advertisement
Car/taxi
• Ideally, the wheelchair should be
placed in the boot.
• If the wheelchair is placed in the back
seat, ensure that it cannot tip over or
roll. Secure it, if possible using the
vehicle's seat belts.
Explanation of symbols
Do not lift the chair
using the legrests.
Do not lift the chair
using the armrests.
Risk of tipping:
Always have the
anti-tip stabilisers
down when moving.
is
1" = 6 kg/cm²/85psi
13/8" =3,5 kg/cm²/50psi
Always check the anti-tip
stabiliser function when adjusting
the seat height, balance position
or backrest angle.
Vehicle transport
Always ensure
the tyre pressure
correct.
Mobility service bus
Etac's wheelchairs are crash-tested and
approved in accordance with
ISO-7176-19 and ISO 10542, with
attachment features and three-point
belts from Unwin.
• The user should transfer to a vehicle
seat, if possible, and use the vehicle's
three-point belt during transport.
The wheelchair must then be secured
so that it cannot tip over or roll.
• If the wheelchair is used as a seat when
travelling, the chair must be facing in
the direction of travel and be fastened
to the vehicle at four points, round the
end/the front castor mountings and
through the transport attachment
(item no. 26158) at the back, as shown
in the picture. The wheelchair must not
be secured through the wheels or round
the back tube.
• Accessories that can be removed without
tools, e.g. trays, must be removed.
The wheelchair's belts are not sufficient
to prevent injury in the event of sudden
braking.
7
Advertisement
Table of Contents
