red lion RL-SPBS Owner's Manual page 2

Before Getting Started
Read and follow safety instructions. Refer to product data plate(s) for additional operating instructions and specifications.
This is the safety alert symbol. When you see this
alert to the potential for personal injury or property damage if ignored:
s
DANGER
! warns about hazards that will cause serious personal injury, death or major property damage if ignored.
s
WARNING
!
s
CAUTION
! warns about hazards that will or can cause minor personal injury or major property damage if ignored.
s
NOTICE
! indicates special instructions which are important but not related to hazards. Carefully read and follow all safety instructions
in this manual and on pump.
s
WARNING
!
WARNING RISK OF ELECTRIC SHOCK - This product is supplied with a grounding conductor and grounding-type attachment plug. To reduce risk
of electric shock, be certain that it is connected only to a properly grounded, grounding-type receptacle. Disconnect power before working on or
around the sump pump or battery backup system.
This equipment should be installed by technically qualified personnel. Comply with national and local electrical and plumbing codes when
installing this unit. Failure to install it in compliance with national and local electrical and plumbing codes and within these recommendations
may result in electrical shock or fire hazard, unsatisfactory performance, or equipment failure. Installation information is available through pump
manufacturers and distributors, or directly from Red Lion® at our toll free number 1-888-956-0000.
This equipment must not be used by children or persons with reduced physical, sensory or mental abilities, or lacking in experience and expertise,
unless supervised or instructed. Children may not use the equipment, nor may they play with the equipment or in the immediate vicinity.
s
CAUTION
!
• Keep work area clean, well-lit, and uncluttered.
• Keep safety labels clean and in good condition.
• Wear safety glasses while installing or performing maintenance on pump.
• Do not run pump dry. Fill pump with water before starting or pump will be damaged.
• Make sure all ELECTRICAL POWER IS OFF before connecting any electrical wires. Wire sump pump system for correct voltages. Follow all pump
wiring instructions provided in the "System Wiring Diagram" and "Electrical Connections" sections of this manual.
2
symbol on your pump or in this manual, look for one of the following signal words and be
warns about hazards that can cause serious personal injury, death or major property damage if ignored.
W A R N I N G
D A N G E R