Failure to comply with national and local electrical and plumbing codes and within Red Lion recommendations may result in electrical Indicates an imminently hazardous situation shock or fire hazard, unsatisfactory performance, or equipment which, if not avoided, will result in death or failure.
Page 3
SAFETY INSTRUCTIONS Before Getting Started High voltages capable of causing severe Risk of bodily injury, electric shock, injury or death by electrical shock are or property damage. present in this unit. • This equipment must not be used by children or persons •...
INSTALLATION Physical Installation INSTALLATION Physical Installation Risk of severe injury or death by electrical shock. • Always disconnect the electrical power before touching the pump or discharge. • Check local electrical and building codes before installation. The installation must be in accordance with their regulations as well as the most recent National Electrical Code (NEC).
Page 6
INSTALLATION Physical Installation 9. Test the operation of the pump system by following the instructions in “Operation Testing” on page 8 this manual. Do not attempt to operate the pump without water; this will damage the seals and bear- ings and could result in permanent damage to the pump. 10.
INSTALLATION Electrical Connections Electrical Connections Risk of severe injury or death by electrical shock. • Always disconnect the electrical power before touching the pump or discharge. • Pumps are supplied with a grounding conductor and grounding-type attachment plug. To reduce risk of electric shock, be certain that it is connected only to a properly grounded grounding-type receptacle.
OPERATION TESTING Testing Pump Operation OPERATION TESTING Risk of damage to pump or other equipment. • Do not attempt to run the pump without water; this could result in permanent damage to the pump. • If pump is run dry, it may damage pump and void the warranty. If the pump does not operate properly, refer to “Troubleshooting”...
MAINTENANCE Periodic Service MAINTENANCE Risk of severe injury or death by electrical shock, high temperatures, or pressurized fluids. • Always unplug the pump power cord and disconnect the electrical power before servicing the pump or switch. • Let pump cool for a minimum of 2 hours before attempting to service. Submersible pumps contain oil that becomes pressurized and hot under normal operating conditions.
MAINTENANCE Troubleshooting Troubleshooting Problem Probable Causes Corrective Action Pump not connected to electrical power. Connect pump to a dedicated circuit equipped with GFCI. Circuit breaker off or fuse removed. Turn on circuit breaker or replace fuse. For models equipped with tethered float Clean float.
MAINTENANCE Replacement Parts Replacement Parts Part Number Description 640171 Tethered Float Switch, Piggyback, 10 ft (3 m) 640172 Tethered Float Switch, Piggyback, 20 ft (6.1 m) 14942904 Vertical Float Switch, Piggyback, 10 ft (3 m)
PRODUCT. The Red Lion® Brand (the “Brand”) warrants that the products accompanied by this Warranty are free from defects in materials or workmanship that exist at the time of sale by the Brand and which occur or exist within the applicable warranty period identified below. Any distributor, sub-distributor, recipient, end-user and/or consumer agrees that by accepting the receipt of the products, the distributor, sub-distributor, recipient, end user and/or consumer expressly agrees to be bound by the terms of this Warranty.
Page 13
The Brand reserves the right at any time, and from time to time, to make changes in the design and/or improvements upon its product without thereby imposing any obligation upon itself to make corresponding changes or improvements in or upon its products already manufactured and/or previously sold.
Page 14
For technical assistance, please contact: 888.885.9254 | redlionproducts.com Form 998491 Rev. 002 04/19...