Replacement Router Bits - Clarke CR4 Operation & Maintenance Instructions Manual

4. Use the scale as a straight edge to confirm this.
5. When correct, lock the parallel guide in that position with the
thumbscrews.
6. Clip the reference scale to the
guide rod, noting that there is a
reference mark (arrow) at the
location shown on the base.
7. Release both guide rods and slide
the guide assembly away from
the router, noting that the scale
shows the distance that the guide
moves away from the cutting bit.
• This will be the maximum offset
distance between the cutting
side of router bit and the
parallel guide touching the
edge of the workpiece.

REPLACEMENT ROUTER BITS

Replacement bits are available from your Clarke dealer as follows:
CHT362:- 15 piece router bit set ¼" shank - Part No 1801362
CHT363:- 15 piece router bit set
Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com
½
" shank - Part No 1801363
20