Before Use - Clarke CR4 Operation & Maintenance Instructions Manual

BEFORE USE

INSTALLING AND REMOVING A ROUTER BIT
WARNING: MAKE SURE THAT THE ROUTER IS ISOLATED FROM POWER
SUPPLY BEFORE YOU CHANGE THE BIT.
WARNING: MAKE SURE THAT YOU USE THE RIGHT SIZE COLLET FOR THE BIT
BEING USED.
WARNING: ONLY USE ROUTER BITS THAT HAVE A SPEED RATING THAT
EXCEEDS THE MAXIMUM SPEED OF THIS ROUTER.
1. Push and hold the spindle lock.
2. Turn the spindle until the spindle
locks into position.
3. Use the spanner supplied to
loosen the collet nut and remove
the bit if one is installed.
4. Slide a bit into the spindle and
tighten the collet nut.
NOTE: At least ¾ of the shank must
be inside the collet.
• Do not tighten the collet nut without a bit installed.
5. Release the spindle lock.
CHANGE THE COLLET SIZE
1. Push and hold the spindle lock.
2. Turn the spindle until it locks into
position.
3. Loosen the collet nut using the
spanner supplied.
4. Carefully remove the collet from
the nut and replace with the
collet you need.
• Your router is supplied with 3
collets, ¼", ⅜" and ½".
5. Replace the nut.
Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com
10