Using The Width Measuring Scale - Clarke CR4 Operation & Maintenance Instructions Manual

1. Remove the two plastic pads from
the parallel guide by removing
the four screws.
2. Attach the Roller Guide using two
of the screws to the two inner
threaded holes of the parallel
guide.
• The Roller Guide wheel should
face away from the parallel
guide, so that the wheel faces
the cutter.
3. Attach the parallel guide fitted
with the Roller Guide to the router
using both guide rods, and secure
using the guide rod locking knobs.
4. Adjust the distance between the
router bit and roller by loosening
the guide rod locking knob on
each side and positioning the
Roller Guide at the correct
distance. Tighten the Knobs to set
the position.
5. Adjust the Roller Guide height if required using the wing nut.
6. To use, hold the router securely with both hands and make the cut by
allowing the Roller Guide to follow the outline shape of the wood. This can
be used for curved workpieces.
NOTE: Ensure the Roller Guide wheel is kept clean and rotates freely.
Lubricate with a suitable PTFE spray if necessary.

USING THE WIDTH MEASURING SCALE

1. With your chosen router bit fitted,
press down on the router so that
the bit protrudes below the base
plate. Lock the router in that
position.
2. Slide the parallel guide assembly
forward until the working face of
the guide is in line with the cutting
edge of the bit.
3. Rotate the bit so that one of the
two cutting blades is in line with the face of the guide.
Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com
19